tag:blogger.com,1999:blog-1928888485923888855.post811790070756258826..comments2024-03-26T06:29:19.110-05:00Comments on Creative Construction: How to make a rod puppet no visible stringsJeffhttp://www.blogger.com/profile/07570822887182643609noreply@blogger.comBlogger5125tag:blogger.com,1999:blog-1928888485923888855.post-31737260902262931842022-09-13T12:28:46.825-05:002022-09-13T12:28:46.825-05:00I used a long thin piece of wire and attached the ...I used a long thin piece of wire and attached the wire to the string. It took some trial and error to get the wire into the holes but once the wire was threaded through I used that and pulled the string through.Jeffhttps://www.blogger.com/profile/07570822887182643609noreply@blogger.comtag:blogger.com,1999:blog-1928888485923888855.post-78825948141158502352022-09-13T11:14:44.259-05:002022-09-13T11:14:44.259-05:00I like this idea. But I do have a question. How in...I like this idea. But I do have a question. How in the world did you get the string though the holes? I can’t figure it out. Anonymousnoreply@blogger.comtag:blogger.com,1999:blog-1928888485923888855.post-79671955121762443262021-04-23T19:07:23.160-05:002021-04-23T19:07:23.160-05:00Notable, mas informacion sobre este tipo de titere...Notable, mas informacion sobre este tipo de titeres donde puedo encontrar, saludos!!jemahttps://www.blogger.com/profile/05270956188055937438noreply@blogger.comtag:blogger.com,1999:blog-1928888485923888855.post-36969832739123471002016-01-15T09:23:00.689-06:002016-01-15T09:23:00.689-06:00The cap on the top with the hole drilled into it i...The cap on the top with the hole drilled into it is to keep the inside rod from wiggling around. It makes it more stable.Jeffhttps://www.blogger.com/profile/07570822887182643609noreply@blogger.comtag:blogger.com,1999:blog-1928888485923888855.post-29504566390314655222014-04-16T13:44:39.583-05:002014-04-16T13:44:39.583-05:00Nice post, Jeff. As another librarian/puppet buil...Nice post, Jeff. As another librarian/puppet builder, I'm happy to see your work and your posts. I think you made a fairly easy solution. I'm not sure why the cap is on the tip where the string goes through - is it just to keep the string close to the rod?<br />KentAnonymousnoreply@blogger.com